“We installed the Stormsaver domestic rainwater harvesting system 8 years ago. The savings on our mains water consumption have been amazing. We are a 4 person household, with 2 kids so lots of baths and clothes washing! We use around 56m3 of mains water a year the same as an average single person household without rainwater harvesting. Our systems provides rainwater for toilets, laundry and irrigation and has reduced our water bill over £200 a year. I specialise in designing and building low energy housing and it is important that I not only research the best available products, but actual experience using them. The Stormsaver system has been simple to install and maintain with very good after market care, I will be using their product again.”
Attenuation
In this day and age it is extremely unlikely that your new build will not have a requirement for some sort of SUDS solution to prevent flooding and ensure that the rainwater that falls on site is dealt with properly.
Traditionally, the attenuation crate solution has been used for most sites, but with maintenance problems and strength issues, is now becoming a less popular choice for many consultants.
Stormsaver offer a simple range of solutions;
- Underground attenuation tanks up to 300,000L in one piece and can be linked in parallel
- Underground infiltration tanks up to 300,000L in one piece and can be linked in parallel
- Underground PE Tunnel system, easy to transport and install and can be maintained
- All of the above, but combined with rainwater harvesting to provide a joined-up solution
All have their benefits and we can help you to determine which solution is best suited to your site. Our data sheets on the products are listed below, but should you have any queries (and we are certain you will) then please call our team who will gladly advise you.
Stormsaver Combined Attenuation, Rainwater Harvesting Tank & Pumping Chamber
At Stormsaver we recommend our combined Rainwater Harvesting and Attenuation Tank with pumping chamber as the best solution for SUDS management.
Stormsaver Combined Attenuation and Rainwater Harvesting
The Stormsaver Combined Rainwater Harvesting and Attenuation Tank is a single piece, GRP, Pre-fabricated system, that is delivered to site for simple and rapid installation.
Stormsaver Attenuation Tank with Pumping Chamber
Our attenuation tank is used to collect all roof and surface water on site, within one vessel. It will be sized to the requirements set out by the consultant in order to attenuate all the rainwater on site and discharge this to the storm drain, or natural water course, at a rate which will not cause downstream flooding.
Stormsaver Tunnels
Stormsaver Tunnels are a new concept for the UK but one which we can guarantee you will see an increasing demand for.
Stormsaver Infiltration Tank and Rainwater Harvesting
The Stormsaver Combined Infiltration and Rainwater Harvesting tank, is a single piece, pre-fabricated GRP tank, which is delivered to site for simple and rapid installation. This system combines the effective infiltration method of attenuation and rainwater harvesting.
Stormsaver Infiltration Tank
The Stormsaver infiltration tank is a single piece, pre-fabricated GRP tank, delivered to site for simple and rapid installation.
