“We installed the Stormsaver domestic rainwater harvesting system 8 years ago. The savings on our mains water consumption have been amazing. We are a 4 person household, with 2 kids so lots of baths and clothes washing! We use around 56m3 of mains water a year the same as an average single person household without rainwater harvesting. Our systems provides rainwater for toilets, laundry and irrigation and has reduced our water bill over £200 a year. I specialise in designing and building low energy housing and it is important that I not only research the best available products, but actual experience using them. The Stormsaver system has been simple to install and maintain with very good after market care, I will be using their product again.”
Stormsaver Attenuation Tank with Pumping Chamber
Attenuation is a crucial part of any new build in order to provide an effective SUDS strategy.
Our stormwater attenuation tanks are used to collect all roof and surface water on site, within one vessel. It will be sized to the requirements set out by the consultant in order to attenuate all the rainwater on site and discharge this to the storm drain, or natural water course, at a rate which will not cause downstream flooding.
Once stored inside the attenuation tank, water is released via the pumping chamber. Pumps can be sized to fit your requirements.
Stormsaver offer a range of solutions, but our attenuation tank, combined with pumping chamber is the most standard solution for most sites. However we would always encourage our clients to consider an option that includes rainwater harvesting too; after all, if you are installing a tank to collect the rainwater, you may as well re-use it too!
Get Started Today
In this section you can download our data sheet which will tell you more technical details and help you to make the decision as to which solution is right for you.